Oasis Concepts Diesel and AC Heating System for Recreational Vehicles and Yachts - Manual (Page 52)

Section 8, Operating the Heating Module
8.4 Turning the Power to the Oasis™
Heating Module ON
• The Oasis™ Heating Module’s main Control Panel, Figure 8-2:
Heating Module Main Control Panel, located on the front of the
module contains three push buttons: ON/OFF power, Bypass,
and Reset. The power switch must be pushed ON (power LED
will turn ON) to turn the DC electrical power to the main
control board and module ON and is required to be left ON
during any period where heat is requested.
• When the Oasis™ Heating Module is shut down for any
extended period or the season, it is recommended that the
power switch be turned OFF.
Figure 8-2 Heating Module Main Control Panel
Do not operate the Oasis™ Heating Module or Distribution
Module (if installed) until a suitable water/anti-freeze solution is
in the modules and all trapped air has been bled or removed.
Use only a non-toxic propylene glycol based coolant with
additives generally recognized as safe ”GRAS” by the FDA in the
Oasis™ Heating Module and Distribution Module.
! DANGER
NOTICE
8-4 The Oasis™ Heating Module