Omega Engineering PSW2000 - Manual (Page 5)

List of functions: (continued)
5
Dialog item Value Description
Only models with analog output:
0 ... xxx Scale the analog output - start value (e. g. 0 bar = 4 mA)
0 ... xxx Scale the analog output - end value (e. g. 400 bar = 20 mA)
(output signal start value always corresponds to the display initial value, e.
g. 0 bar = 4mA)
Maximum turn-down 4 : 1, i.e. at values below 25 % of the measuring range
the analog output is switched off
0 ... xxx Display of peak value "Max" (xxxx: = max. 125 % f. s.)
.... Delete the maximum value memory
Error display:
Note:
When changing units from psi to bar or bar to psi, the switching point values must be changed accordingly.
= exceeding neg. measuring range
= sensor error
= no error
= exceeding pos. measuring range
= data error (EEProm)
= program error
= error switching output 1
= error switching output 2
= calibration error
= error analog out
= no deletion
= delete value
PSW2000.qxp 6/12/2008 10:38 AM Page cov-7