Oregon ATC Mini Action Camera ATCmini - Manual (Page 19)

ATCMini – 17
EN FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
720p (1280 x 720 pixels); 16:9; 30fps; ~8Mbit / s data rate, approximately
6 or above
en.indd 17 8/9/2011 1:17:13
FCC Note
WARNING
* Shielded USB cable and RCA cable with ferrite must be used with this unit to ensure
compliance with the class B FCC limits.