Onkyo AV RECEIVER HT-RC470 - Manual (Page 62)

Advanced Operations
En-62
■ DTS/DTS-ES/DTS-HD
With this setting, you can specify the listening mode
used when DTS or DTS-HD High Resolution format
digital audio signals are played (DVD, LD, CD, etc.).
Specifies the default listening mode for DTS-HD Master
Audio sources, such as Blu-ray or HD DVD (input via
HDMI).
■ Other Multich Source
Specifies the default listening mode for multichannel
PCM sources from HDMI IN such as DVD-Audio, and
DSD multichannel sources such as Super Audio CD.
Main Menu Miscellaneous
Volume Setup
■ Volume Display
` Absolute:
Displayed range is Min, 1 to 99, Max.
` Relative (THX):
Displayed range is – dB, –81dB to +18dB.
With this setting, you can choose how the volume level is
displayed.
The absolute value 82 is equivalent to the relative value
0 dB.
Note
• If the absolute value is set to 82, “82Ref” will appear on the
display and the THX indicator will flash.
■ Muting Level
` – dB (fully muted), –50dB to –10dB in 10 dB steps.
This setting determines how much the output is muted when
the muting function is used (
➔ page 44 ).
■ Maximum Volume
` Off , 50 to 99 (Absolute display)
` Off, –32dB to +17dB (Relative display)
With this setting, you can limit the maximum volume.
To disable this setting, select “Off”.
■ Power On Volume
` Last, Min, 1 to 99 or Max (Absolute display)
` Last , – dB, –81dB to +18dB (Relative display)
With this preference, you can specify the volume setting to
be used each time the AV receiver is turned on.
To use the same volume level that was used when the AV
receiver was turned off, select “Last”.
The “Power On Volume” setting cannot be set higher than
the “Maximum Volume” setting.
■ Headphone Level
` –12dB to 0dB to +12dB
With this setting, you can specify the headphone volume
relative to the main volume. This is useful if there’s a
volume difference between your speakers and your
headphones.
Miscellaneous
1 2 3 4 5
“Setup”