Onkyo AV RECEIVER HT-RC470 - Manual (Page 69)

Advanced Operations
En-69
■ Operating on the AV receiver
Tip
• The Whole House Mode function shares the input source of main
room with Multi Zone ( ➔ page 44 ).
■ Operating on the remote controller
To control Zone 2/3, you must press ZONE2 or ZONE3
on the remote controller first.
Adjusting the Volume for Zone 2
■ Operating on the remote controller
■ Operating on the AV receiver
If your Zone 2 speakers are connected to a receiver or
integrated amplifier in Zone 2, use its volume control to
adjust the volume.
Muting Zone 2
■ Operating on the remote controller
Tip
• To unmute, press ZONE2 followed by MUTING again. Zone can
also be unmuted by adjusting the volume.
Note
• Only analog input sources are output from the ZONE 2/ZONE 3
LINE OUT jacks and ZONE 2 L/R terminals. Digital input
sources are not output. If no sound is heard when an input source
is selected, verify that the source is connected to an analog input.
• You cannot select different AM or FM radio stations for your
main room and Zone 2/3. The same AM/FM radio station will be
heard in each room. Namely, if you have selected an FM station
for the main room, that station will also be output in Zone 2/3.
• When you have selected NET or USB as input selector, the last
selector selected will be set for Main room and Zone 2/3.
• When Zone 2/3 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
• While Zone 2/3 is on, functions will not work.
• When setting the AV receiver to standby mode while Zone 2/3 is
active, the Z2 or Z3 indicator is dimly lit.
• “AUX”, “EXTRA1” and “EXTRA2” cannot be selected as input
sources for Zone 2/3.
• When “AUX”, “EXTRA1” or “EXTRA2” is the input source of
Main room and Zone 2/3 is set to share the same source, no sound
will be output from Zone 2/3.
Controlling Multi Zone Components
1 To turn on Zone 2/3 and select an input source,
press
ZONE 2 or ZONE 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.
To select the same source as the main room’s, press
ZONE 2 or ZONE 3 twice. “Z2 Sel: Source” or “Z3
Sel: Source” appears on the AV receiver’s display.
2 To turn off Zone 2/3, press ZONE 2 or ZONE 3
followed by ON/STANDBY within 8 seconds.
The zone is turned off.
ZONE 2 ZONE 3 MASTER VOLUME
ON/STANDBY
Input selector buttons
1 Press ZONE2 or ZONE3, then point the remote
controller at the AV receiver and press
RECEIVER.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.
2 To select an input source for Zone 2/3, press
ZONE2 or ZONE3, followed by an INPUT
SELECTOR button.
3 To turn off Zone 2/3, press ZONE2 or ZONE3,
followed by RECEIVER.
The zone is turned off.
1 Press ZONE2.
2 Use VOL / .
1 Press ZONE 2 (the Z2 indicator on the AV
receiver’s display flash).
2 Use MASTER VOLUME control within 8 seconds.
RECEIVER
ZONE2
ZONE3
INPUT
SELECTOR
VOL /
MUTING
1 Press ZONE2 followed by MUTING.