Onkyo CR-715 - Manual (Page 11)

11
Getting to Know the CD Receiver—Continued
L Onkyo MD recorder and cassette deck
control buttons
For twin cassette decks, only Deck B can be con-
trolled.
: Plays side B (cassette deck).
: Pauses playback or recording (MD).
: Stops playback, recording, fast-forward, or
rewind.
: Plays side A.
M CLOCK CALL button (48)
Calls up the clock to display the day and time.
N INPUT [ ]/[ ] buttons (25, 27, 41, 43)
Used to select the input source.
O DISPLAY button (29, 32, 37, 39, 44, 48)
Used to change the information shown on the dis-
play. Also used to select characters when naming
radio presets. Can also be used with an Onkyo CD
recorder. With an Onkyo RI Dock, it works as a
backlight button.
P FOLDER button (30, 31, 32, 35)
Used to select MP3 folders.
Q REPEAT button (34)
Sets repeat playback. Can also be used with an
Onkyo RI Dock or CD recorder. With an Onkyo
cassette deck, it works as a reverse mode button.
R TONE button (26)
Used to adjust the bass and treble.
S YES/MODE/SHUFFLE button (32–34, 36)
Used with various functions and settings for con-
firming, selecting modes, and selecting shuffle play-
back.
T ENTER button
Used to confirm various functions and settings. Can
also be used with an Onkyo RI Dock or CD
recorder.
U MUTING button (26)
Mutes the output of the CD receiver.
V TUNER/BAND button (36, 38, 41, 42, 43)
Selects FM, or DAB radio as the input source.
When you operate the remote controller, point it at the
CD receiver’s remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the CD
receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in
mind when installing.
• If another remote controller of the same type is used
in the same room, or the CD receiver is installed close
to equipment that uses infrared rays, the remote con-
troller may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the CD
receiver is installed in a rack behind colored glass
doors. Keep this in mind when installing.
• The remote controller will not work if there’s an
obstacle between it and the CD receiver’s remote con-
trol sensor.
Using the Remote Controller
Appro
x. 5 m
(16 ft.)
Remote control sensor
CD receiver