Onkyo CR-715 - Manual (Page 55)

55
Troubleshooting—Continued
Can’t add tracks to the playlist for memory playback.
• Make sure there’s a disc in the CD receiver. Also, you can only add valid track numbers. For example, if the CD
contains 11 tracks, you cannot add track #12.
The disc will not play.
• Make sure the disc has been loaded correctly, with the label-side facing up.
• Check to see if the surface of the disc is dirty (see page 13).
• If condensation is suspected, turn on the CD receiver and leave it for 1 hour before playing any discs.
• Some CD-R/RW discs may not be playable (see page 12).
It takes a long time for playback to start.
• It may take the CD receiver a while to read CDs that contain many tracks or files.
Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn’t preset all stations, or
the ST indicator doesn’t light up when tuned to a stereo FM station.
• Check the antenna connections (see page 14).
• Change the position of the antenna (see page 36).
• Move the CD receiver away from a nearby TV or computer.
• Cars or airplanes can cause noisy interference.
• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
• Try setting FM mode to mono (see page 36).
• Move power cords and speaker cables as far away as possible from the tuner’s antenna.
• If none of the above improves the reception, install an outdoor antenna (see page 15).
If a power outage occurs or the power cable is disconnected:
• If the preset stations are lost, preset them again (see pages 41, 42).
• The clock and timer settings will be lost. Set the clock and timers again (see pages 47, 48).
Can’t adjust the frequency of the radio.
• Use the tuning [ TUN]/[TUN ] buttons to change the frequency of the radio (see page 36).
RDS doesn’t work.
• The FM station you are tuned to doesn’t support RDS.
• Install an outdoor FM antenna (see page 15).
• Change the position or direction of your outdoor FM antenna (see pages 15, 36).
• Move the FM antenna as far away as possible from fluorescent lights (see page 36).
The remote controller doesn’t work properly.
• Make sure the batteries have been installed with the correct polarity (+/–) (see page 5).
• Replace both batteries with new ones. (Do not mix different types of batteries or new and old batteries.)
• The remote controller is too far away from the CD receiver, or there’s an obstacle between them (see page 5).
• The CD receiver’s remote control sensor is being subjected to bright light (inverter-type fluorescent light or sunlight).
• The CD receiver is located behind the glass doors of a audio rack or cabinet.
Interactive control with other Onkyo -capable components is not working.
• Make sure the cables and analog audio cables are connected correctly (see pages 18 to 22). Connecting only an
cable won’t work.
• Make sure the Input Display matches the type of device that you’ve connected to the CD receiver (see page 27).
• When recording an MP3 CD to an Onkyo recording component, recording will start without performing a peak search
when the [CD DUBBING] button is pressed on the recording component. This is not a malfunction.
Tuner
Remote Controller
External Components