Onkyo TX-SR603X - Manual (Page 37)

37
Connecting the AV Receiver —Continued
• Before connecting the power cord, connect all your
speakers and AV components.
• Turning on the AV receiver may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV receiver into a different circuit.
Notes:
• Pressing the remote controller’s [ON] button once will
turn on the AV receiver. Pressing it again will turn on
any components connected via
.
• When the AV receiver is on Standby, it will turn on
automatically when any one of its input selector but-
tons is pressed.
• Before disconnecting the power cord from the wall
outlet, set the AV receiver to Standby.
Turning On the AV Receiver
1 Plug the power cord into an AC
wall outlet.
The STANDBY indicator will light up.
2 Press the [STANDBY/ON] button.
Alternatively, press the remote
controller’s [RECEIVER] button
followed by the [ON] button.
The AV receiver comes on, the display
lights up, and the STANDBY indicator
goes off.
To turn off the AV receiver, press the
[STANDBY/ON] button. The AV
receiver will enter Standby mode.
10 - - / - - - 11 12
+
-
T V CH
T V VOL
INPUT SELECTOR
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
INPUT I
ON STANDBY T V
CD
V1 V2 V3
MULTI CH DVD
TUNER
V4
TAPE
STANDBY/ON
STANDBY
ON
To wall outlet
STANDBY indicator
STANDBY
STANDBY/ON
STANDBY
ON
Remote
controller