Oki C3400 - Manual (Page 18)

Network User’s Guide for C3400n and C3530 MFP
Windows - 18
without a DHCP server, you must assign the IP address manually. For
instructions on how to do this, see “Manually configuring the IP address” on
page 18.
Now that both Windows and the printer have been configured to use TCP/IP,
the next step is to configure Windows to print to the network printer.
S
TARTING THE
N
ETWORK
C
ARD
S
ETUP UTILITY
Once installed, you can launch the Network Card Setup utility by selecting
Start -> Programs -> Okidata -> Network Card Setup.
M ANUALLY CONFIGURING THE IP ADDRESS
If there is no DHCP protocol to automatically assign IP addresses to devices
on your network, you might want to set the IP Address, Subnet Mask and
Default Gateway Address for your printer manually.
1. In the “Network Card Setup” pane, click to select the printer.
2. Click the Setting Printer icon. The Setting Printer dialog appears.
3. Select “Manual”. In the Details section, you can now edit the IP
Address, Subnet Mask and Default Gateway Address.
4. Click OK. The “Admin Password Required” dialog appears.
5. Enter the password. The default password is the last 6 digits of the
MAC Address (upper case).
6. Click OK. Allow a few seconds for the changes to save and the printer
to automatically restart before the “Setup Completed” message box
appears.
NOTE:
If your printer stops at any time, you can restart it by selecting Printer ->
Restart Printer in the “Network Card Setup pane”.
C HANGING THE A DMIN P ASSWORD
To change the Admin Password for your printer:
1. Select Settings -> Change Password.
2. Enter the new password as requested.
3. Click OK. Allow a few seconds as the settings are saved and the
printer automatically restarts.