Onkyo A-9555 - Manual (Page 14)

14
Enjoying Audio Sources
If the A-9755/A-9555 is connected to other compo-
nents via
, press the remote controller’s [ON] but-
ton once to turn on the A-9755/A-9555, and press it
again to turn on the other components.
Turning on all system components simultaneously:
You can set the A-9755/A-9555 so that all connected
components are turned on with just one press of the
remote controller’s [ON] button. To do this, turn on the
A-9755/A-9555, and then press and hold the remote con-
troller’s [ON] button for 16 seconds until the
A-9755/A-9555 switches to Standby mode. You will
then be able to turn on the A-9755/A-9555 and all sys-
tem components with just one press of the remote con-
troller’s [ON] button.
If you want to restore the setting to the original state,
reset the A-9755/A-9555. For information about how to
reset, see “How to reset” on page 19.
Note:
To shut down the A-9755/A-9555 completely, set the
[POWER] switch to the OFF position (
).
You can select which set of speakers outputs sound.
OFF: Select “OFF,” if you do not connect any speaker.
A: To output sound from the speakers connected to the
SPEAKERS A terminals, turn the SPEAKERS selector
to the “A” position.
B: To output sound from the speakers connected to the
SPEAKERS B terminals, turn the SPEAKERS selector
to the “B” position.
A+B: To output sound from all connected speakers, turn
the SPEAKERS selector to the “A+B” position.
Note:
If the Volume indicator flashes quickly, make sure that
the speakers are connected correctly.
Turning On the A-9755/A-9555
1 Press the [POWER] switch.
The A-9755/A-9555 retains the power
mode (on/standby) in which the ampli-
fier was the last time you turned off the
system.
Notes:
• The A-9755/A-9555 is shipped with
the [POWER] switch in the OFF
position (
). When the power cord
is connected for the very first time or
the [POWER] switch is set to ON
(
) position, the A-9755/A-9555
will turn on.
• When it’s turned on, the
A-9755/A-9555 outputs no sound
for about five seconds. This allows
the circuits to stabilize.
2 To set the A-9755/A-9555 to
Standby, press the [STANDBY]
button on the remote controller.
The STANDBY indicator lights up.
To turn the A-9755/A-9555 on,
press the [ON] button on the
remote controller.
The STANDBY indicator goes off.
POWER
ON
STANDBY
STANDBY
indicator
A-9755/
A-9555
Remote
controller
Selecting Speaker