Osburn Stoves by SB I HYBRID 35 - Manual (Page 6)

6
FREESTANDING INSTALLATION
HYBRID-35 FREESTANDING PELLET STOVE
Width: 22 1/2”
Height: 29”
Depth: 24 1/2”
Weight: 195 lbs.
Flue size: 3” or 4”
Hopper Capacity: Up to 35 lbs.
(This can vary slightly depending on pellet size, length, and diameter)
EPA status: exempt
Burn rate: 1.3 lbs to 4.1 lbs per hour
BTU range: 8,200 to 35000
Electrical consumption: 3.5 Amps lighting cycle
2.5 Amps. continuous duty
Control board fuses: Main: 7.5A-250V fastblow
Igniter: 5A-250V fastblow
Electrical requirement: 120VAC 15A
Approved installations: mobile home, conventional
PREPARATION
Factory packaging must be removed, and some minor assembly work is
required prior to installation:
• The door overlay must be installed on the door frame;
• The louver kit must be installed in front of the heat exchanger;
•
The black knob must be attached to the heat exchanger rod;
•
The pedestal kits must be assembled to the body (freestanding
version);
• The faceplate kit must be assembled to the body (insert version);
• Filters may be inserted between the finger guards and the
convection blowers (see “filters assembly” section).
NOTE: The detailed instructions required to assemble the pedestal kit or
faceplate kit are supplied with the corresponding kit. Normally, your dealer
will perform these functions.
To remove ashes, use the ash pan or a vacuum cleaner. If you want to
use the ash pan, you will have to remove the plate located at the right side
of the burn pot.
1- Remove the three screws
2- Remove the plate
3- Put the three screws back
4- Use the ash dump cap provided with the stove
SI
D
E
W
A
L
L
6"
BACK WALL
2" *
3"
Figure 1
Back wall installation
2"
3"
3"
2"
ADJACENT WALL
AD
JA
CENT
W
A
LL
Figure 2
Corner installation