Onkyo TX-NR709 - Manual (Page 44)

44
En
Main Menu Input/Output Assign
Monitor Out
If you connect your TV to HDMI output, “Monitor Out”
setting is automatically set so that the onscreen setup
menus are displayed and composite video, S-Video, and
component video sources are upconverted
* and output.
Note
• See “Video Connection Formats” ( ➔ page 83) for charts
showing how the “Monitor Out” and “Resolution” settings
affect the video signal flow through the AV receiver.
■ Monitor Out
` HDMI Main:
Select this if your TV is connected to HDMI OUT
MAIN.
` HDMI Sub:
Select this if your TV is connected to HDMI OUT
SUB.
` Both:
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs at the resolution
supported by both TVs.
`
Both(Main):
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs but HDMI OUT
MAIN will become a priority; depending on the
resolution, video signals may not be output from
HDMI OUT SUB.
`
Both(Sub):
Select this if your TVs are connected to HDMI OUT
MAIN and HDMI OUT SUB. Video signals are
output from both HDMI outputs but HDMI OUT
SUB will become a priority; depending on the
resolution, video signals may not be output from
HDMI OUT MAIN.
Note
• When using the DeepColor function, if the “Monitor Out”
setting is set to “Both(Main)” or “Both(Sub)”, the number of
bits may be limited due to the capability of your TV connected
to a priority output.
■
Resolution
` Through:
Select this to pass video through the AV receiver at
the same resolution and with no conversion.
`
Auto:
Select this to have the AV receiver automatically
convert video at resolutions supported by your TV.
` 480p (480p/576p), 720p, 1080i, 1080p:
Select the desired output resolution.
` 1080p/24:
Select this for 1080p output at 24 frames per second.
` 4K Upscaling:
Select this for an output resolution four times that of
1080p, resulting in 3840 × 2160 pixels.
You can specify the output resolution for the HDMI OUT
MAIN and have the AV receiver upconvert the picture
resolution as necessary to match the resolution supported
by your TV.
Note
• Depending on the incoming video signal, the video playback
may not be smooth or the vertical resolution may be lowered. In
this case select anything other than “1080p/24”.
• If the “Monitor Out” setting is set to “Both”, this setting is fixed
to “Auto”.
• When “Monitor Out” is set to either “HDMI Sub” or
“Both(Sub)”, the “Resolution” setting is fixed to “Through”.
Input/Output Assign
IN
OUT
Composite video, S-Video,
component video HDMI
HDMI Composite video, S-Video,
component video