Speaker setup, E “subwoofer input sensitivity, Speaker settings – Onkyo TX-NR709 User Manual

Page 46

Advertising

Digital Audio Input

If you connect a component to a digital audio input, you
must assign that input to an input selector. For example, if
you connect your CD player to the OPTICAL IN 1, you
must assign “OPTICAL1” to the “TV/CD” input
selector.
Here are the default assignments.

■

BD/DVD, VCR/DVR, CBL/SAT, GAME, PC,
TV/CD, PHONO, PORT

COAXIAL1, COAXIAL2, COAXIAL3,
OPTICAL1, OPTICAL2:

Select a corresponding digital audio input to which
the component has been connected.

- - - - -:

Select if the component is connected to an analog
audio input.

Note

• When an HDMI IN is assigned to an input selector in “HDMI

Input” (

➔

page 45), the same HDMI IN will be set as a priority

in this assignment. In this case, if you want to use the coaxial or
optical audio input, make the selection in the “Audio Selector”
(

➔

page 55).

• Available sampling rates for PCM signals from a digital input

(optical and coaxial) are 32/44.1/48/88.2/96 kHz/16, 20, 24 bit.

• If you connect a component (such as UP-A1 Dock with docked

iPod/iPhone) to the UNIVERSAL PORT jack, you cannot
assign any input to the “PORT” selector.

• The “AUX” selector is fixed to the “- - - - -” option.
• The “TUNER” selector cannot be assigned and is fixed to the

“- - - - -” option.

Analog Audio Input

Some DVD players output the LFE channel from their
analog subwoofer output at 15 dB higher than normal.
With this setting, you can change the AV receiver’s
subwoofer sensitivity to match your DVD player.

■

Subwoofer Input Sensitivity

0dB

to 15dB in 5 dB steps.

Note

• This setting only affects signals connected to the AV receiver’s

multichannel input subwoofer jack.

• If you find that your subwoofer is too loud, try the 10 dB or

15 dB setting.

Main menu

Speaker Setup

Here you can check the settings made by
Audyssey MultEQ XT Room Correction and Speaker
Setup function, or set them manually, which is useful if
you change one of the connected speakers after using
Audyssey MultEQ XT Room Correction and Speaker
Setup function.

Note

• These settings are not available in either of the following cases:

– a pair of headphones is connected.
– the “Audio TV Out” setting is set to “On” (

➔

page 59).

– “HDMI Control(RIHD)” is set to “On” (

➔

page 58) and

you’re listening through your TV speakers.

Speaker Settings

If the impedance of any speaker is 4 ohms or more but less
than 6, set the minimum speaker impedance to 4 ohms.
If you bi-amp the front speakers, you must change the
“Speakers Type(Front)” setting (

➔

page 46). For

hookup information, see “Bi-amping the Front Speakers”
(

➔

page 14).

Note

• When bi-amping is used, the AV receiver is able to drive up to

5.1 speakers in the main room.

• Before you change these settings, turn down the volume.

■

Speaker Impedance

4ohms: