Onkyo 144 - Manual (Page 5)

5
L R L R
(REC)(PLAY)
LINE IN LINE OUT
L L
R
(REC) (PLAY)
R
VOLTAGE SELECTOR
220-230V 120V
REMOTE
CONTROL
Amplifier
System connections
• Do not plug in the AC power cord until all other connections have been made.
• On each pair of input or output jacks, the lower jack (marked R) corresponds to the right channel, and the upper jack (marked L) to
the left channel. Refer to the amplifier’s instruction manual for further information on connections.
To AC outlet
Connecting to an amplifier
Connect the tape deck LINE IN
jacks to the TAPE REC jacks on
the rear panel of the amplifier and
the tape deck LINE OUT jacks to
the amplifier TAPE PLAY jacks.
Refer to the amplifier’s instruction
manual for further information on
connections. See "Connecting ONKYO components
for
z operation" on page 12.
Power connections
Switching power on
TA-RW144:
1. Plug the AC power cord into a wall
outlet.
The STAND-BY indicator will light.
2. Press the POWER button.
The STAND-BY indicator will go out
and the display will light.
TA-RW244:
1. Plug the AC power cord into a wall
outlet.
2. Press the MAIN POWER button.
The STAND-BY indicator will light.
3. Press the STAND-BY/ON button.
The STAND-BY indicator will go out
and the display will light.
• Pressing the a or s button of either
Deck A or Deck B when the unit is in
standby status will also cause the
display to light and playback will start.
• If the tape deck is plugged into the
amplifier’s AC outlet, the amplifier’s
AC power cord must be plugged into a
wall outlet and its power switched on
before the tape deck can operate.
POWER
STAND-BY
1
2
3
See "Power
connections"
below.
MAIN POWER
STAND-BY
(TA-RW144) (TA-RW244)
STAND-BY/ON
STAND-BY
(TA-RW244 only)
(TA-RW144 only)
POWER
STAND-BY