Oregon WRB308 - Manual (Page 9)

EN
9
REMOTE SENSOR
2 x UM-3 (AA) 1.5V batteries
Insert batteries before first use, matching the polarity (+
and -) as shown in the battery compartment. Press
RESET after each battery change.
shows when batteries are low.
UNIT LOCATION
Remote sensor Outdoor Temperature / Humidity Area
NOTE Do not use rechargeable batteries in the remote
sensor. It is recommended that you use alkaline batteries
with this product for longer performance and lithium
batteries in colder climates. Please dispose of used
batteries properly to prevent harm to the environment.
AC / DC ADAPTER
Insert the adapter into the weather station to turn it on
and allow charging for the radio.
REMOTE SENSOR (RTGR328NA)
This remote temperature-humidity sensor can receive
and transmit atomic clock signals, collect outdoor
temperature and humidity readings, and then relay them
back to the weather station. It can be used with up to 4
other remote temperature-humidity sensors.
NOTE Additional remote sensors that measure
temperature and humidity are sold separately.
SET UP SENSOR
1. Open the battery compartment with a small Phillips
screwdriver.
2. Set the channel number (1-5). If you are using
more than one remote unit, select a different
WRB308 M_EN_V6.P65 2005.5.31, 12:10 9