Oki 391 - Manual (Page 50)

50 Microline 390/391 Turbo
|
Automatic Forms Tear-Off
Forms Tear-Off must be set to ON in the menu for Automatic
Forms Tear-Off to occur.
Automatic Forms Tear-Off automatically moves the paper
from the initial printing position (print start position) to the
tear-off position, after a time interval which you select
through the menu.
The top of the page (perforation) is even with the tear bar.
The tear bar is located under the clear top of the access cover.
Paper remains in the tear-off position until the printer
receives more data. Then, the paper moves back down for
printing (retracts to the initial print position).
When printing stops, the paper advances to the tear-off
position.
TEAR Key and Automatic Forms Tear-Off
If you press TEAR (1) when Forms Tear-Off is turned on
(activated in the printer menu), the printer retracts the paper
to the Top of Form position.
32T-FP.eps
QUIET PARK TEAR FF/LOAD LF SEL
SEL
POWER ALARM MENU
GROUP EXIT ITEM SET PRINT
MENU SHIFT TOF Micro Feed
Up
Micro Feed
Down
! The status of the Forms Tear-Off menu setting affects
how you set the Top of Form.
To determine the status of the Forms Tear-Off menu
setting, refer to “Using Your Printer, Top of Form,
Forms Tear-Off Status (ON or OFF).”
For information on setting the Top of Form, refer to
“Using Your Printer, Top of Form, Setting Top of Form,
Forms Tear-Off (ON or OFF).”
! If the software package you are using “pauses” while
sending data to the printer, Forms Tear Off may be
activated (if it is enabled through the Menu). The pause
must be for two or more seconds. No data is lost. Uneven
print registration will occur due to the paper movement.
If the problem occurs, use the menu to turn off this
feature.
! DO NOT use Forms Tear Off with labels or multi-part
forms!
! Forms Tear-Off CANNOT be used when the optional
pull tractor is engaged.
1