Onkyo TX-SR8450 - Manual (Page 56)

56
Advanced Setup —Continued
Speaker Distance
With these settings, you can specify the distance from
each speaker to the listening position.
Notes:
• The Center and Subwoofer distances can be set up to
5 ft. (1.5 m) more or less than the Front distance. For
example, if the Front distance is set to 20 ft. (6 m), the
Center and Subwoofer distances can be set between 15
and 25 ft. (4.5 and 7.5 m).
• The Surround and Surround Back distances can be set
up to 5 ft. (1.5 m) more or 15 ft. (4.5 m) less than the
Front distance. For example, if the Front distance is set
to 20 ft. (6 m), the SurrRight, Surr Left, Surr Back R,
and Surr Back L distances can be set between 5 and 25
ft. (1.5 and 7.5 m).
Speaker Levels
You can set the volume level of each speaker so that all
speakers can be heard equally at the listening position.
1 Measure and make a note of the
distance from each speaker to
the listening position.
2 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
3 Use the Up and Down [ ]/[ ]
buttons to select “2. SP Dis-
tance,” and then press [ENTER].
4 While “Unit” is displayed, use the
Left and Right [
]/[ ] buttons to
select “feet” or “meters”.
feet: Distances can be set in feet.
Range: 1 to 30 feet in 1-foot
steps.
meters: Distances can be set in
meters. Range: 0.3 to 9
meters in 0.3-meter steps.
5 Use the Down [ ] button to
select “Front,” and use the Left
and Right [
]/[ ] buttons to
specify the distance for the front
speakers, then press the Down
[
] button to select the next
speaker.
6 Repeat step 5 for all speakers.
Note:
Speakers that you set to No or None in
the Speaker Configuration (page 34)
cannot be selected.
7 Press the [SETUP] button.
Setup closes.
SETUP
RECEIVER
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
2 Use the Up and Down [ ]/[ ]
buttons to select “3. Level Cal,”
and then press [ENTER].
A pink noise test tone is output by the
front left speaker.
3 Turn up the volume so that you
can hear the test tone suffi-
ciently.
As each speaker outputs the test tone,
its name appears on the display.
The speaker levels cannot be adjusted while a
pair of headphones is connected, speaker set
B is on, or the AV receiver is muted.
SETUP
RECEIVER