Onkyo HT-R390 - Manual (Page 18)

18
En
Playback
■
Operating with the remote controller
■
Operating on the AV receiver
Using the Tuner
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets for
quick selection.
You can change the frequency steps (
➔
page 34).
Tuning into Radio Stations
■
Auto tuning mode
The on-screen menus appear only on a TV that is
connected to the
HDMI OUT. If your TV is connected
to the MONITOR OUT V or the COMPONENT
VIDEO OUT, use the AV receiver’s display when
changing settings.
This manual describes the procedure using the
remote controller unless otherwise specified.
Playing the Connected Component
1 Press RECEIVER followed by INPUT
SELECTOR.
2 Start playback on the source component.
See also:
• “Listening to AM/FM Radio” (
➔
page 18)
• “iPod/iPhone Playback via Onkyo Dock”
(
➔
page 38)
• “Controlling Other Onkyo Components”
(
➔
page 41)
3 To adjust the volume, use VOL / .
4 Select a listening mode and enjoy!
See also:
• “Using the Listening Modes” (
➔
page 21)
1 Use the input selector buttons to select the input
source.
2 Start playback on the source component.
3 To adjust the volume, use the MASTER VOLUME
control.
4 Select a listening mode and enjoy!
Listening to AM/FM Radio
This section describes the procedure using the
buttons on the front panel unless otherwise specified.
1 Press TUNER to select either “AM” or “FM”.
In this example, FM has been selected.
Each time you press TUNER, the radio band changes
between AM and FM.
(Actual display depends on the country.)
1 Press TUNING MODE so that the AUTO indicator
lights on the display.
2 Press TUNING / .
Searching stops when a station is found.
When tuned into a station, the TUNED indicator
lights. When tuned into a stereo FM station, the FM
STEREO indicator lights on the display, as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
• Alternatively, you can use the remote controller’s TUN
MODE and arrow buttons.
Band Frequency
FM STEREO
AUTO
TUNED