Onkyo HT-R390 - Manual (Page 30)

30
En
Menu Sp Distance
Here you can specify the distance from each speaker to the
listening position so that the sound from each speaker
arrives at the listener’s ears as the sound designer
intended.
Note
• These settings are disabled when:
– a pair of headphones is connected, or
– the “Audio TV Out” setting is set to “On” (
➔ page 35), or
– “HDMI Ctrl (RIHD)” is set to “On” (
➔
page 34) and
you’re listening through your TV speakers, or
– Speakers B is on, or
– Speakers A is off.
• Speakers that you set to “No” or “None” in the “Sp Config
(Speaker Configuration)” (
➔ page 29) cannot be selected.
■
Unit
` feet:
Distances can be set in feet. Range: 1ft to 30ft in
1 foot steps.
`
meters:
Distances can be set in meters. Range: 0.3m to 9.0m
in 0.3 meter steps.
(The default setting varies from country to country.)
■
Left, Center, Right, Surround Right, Surround
Left, Subwoofer
`
Specify the distance from the each speaker to your
listening position.
Menu Level Cal
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
■ Left, Center *1 , Right, Surround Right, Surround
Left
` –12 dB to 0 dB to +12 dB in 1 dB step.
■ Subwoofer *1
`
–15 dB to 0 dB to +12 dB in 1 dB step.
Default setting: 0 dB (excluding European models),
+3 dB (European models)
Note
• Speakers that you set to “No” or “None” in the “Sp Config
(Speaker Configuration)” (
➔
page 29) cannot be selected.
• These settings cannot be calibrated in either of the following
cases:
– a pair of headphones is connected.
– Speakers B is on.
– Speakers A is off.
– the “Audio TV Out” setting is set to “On” (
➔
page 35).
– “HDMI Ctrl (RIHD)” is set to “On” ( ➔ page 34) and
you’re listening through your TV speakers.
– the AV receiver is muted.
*1 For the center speaker and subwoofer, the level settings made
by using AUDIO are saved here as the default settings.
Tip
• If you’re using a handheld sound level meter, adjust the level of
each speaker so that it reads 75 dB SPL at the listening position,
measured with C-weighting and slow reading.
• To fully enjoy Audyssey Dynamic EQ ® (
➔ page 32) and
Audyssey Dynamic Volume ® ( ➔ page 32), we recommend
that you manually adjust the level of each speaker using the
above-mentioned settings.
Sp Distance (Speaker Distance) Level Cal (Level Calibration)