OPPO Digital OPPO DV-970HD - Manual (Page 35)

S E T U P M E N U O P T I O N S
31
• On – Pro Logic II processing is always on
• Off – No Pro Logic II processing
• Auto – Pro Logic II processing is on only when Dolby Pro Logic II encoded content
is detected.
B. Mode: To set the processing mode of Pro Logic II. The options are:
• Music – Sound from all speakers arrive at the same time with no delay
• Movie – 10ms delay is added to the surround channels
• Pro Logic – Earlier version of Dolby Pro Logic processing
• Auto – Automatically selects processing mode based on content
C. Panorama: To turn on/off panorama mode. When turned on, front stereo audio is
extended to the surround channels for an enveloping effect.
D. Dimension: To increase or decrease the dimensional effect by adjusting the front to
rear balance. As the size number increases, the sound localization moves towards
forward from backward.
E. Center Width: To control the width of the center channel sound effect by blending the
center speaker to the left and right speakers. As the level number increases, the center
channel sound moves toward the left and right speakers.
7. Dolby Digital Setup: To configure the Dolby Digital decoder.
• Press the SELECT button to enter the Dolby Digital Setup page.
• Press the LEFT ARROW button to exit the Dolby Digital Setup page.
A. Dual Mono: To choose the output for Dolby Digital discs encoded with two independent
audio channels, such as bilingual programs. The options are:
• Stereo – Stereo output
• L-Mono – Left channel output to both Left and Right speakers.
• R-Mono – Right channel output to both Left and Right speakers.
• Mix Mono – Left and Right channels mixed to both Left and Right speakers.
B. Dynamic: To set the Dynamic Range Compression (DRC). DRC can smooth out the
sonic peaks and valleys common with wide-range digital audio. Increasing DRC may
make low level audio more audible during low-level listening. Decreasing or turning off
DRC restores the sonic energy present in the original recording.
8. HDMI Audio: To select digital audio output from the HDMI port. The options are:
• Multi-Channel – Digital audio output via HDMI will be multi-channel PCM format. The
Down-mix setting in the “Speaker Setup Page” will affect whether and how multi-channel
audio content will be down-mixed to stereo. When this option is selected, compressed
audio bit streams will decoded by the DVD player.
• SPDIF – Digital audio output via HDMI will be the same as the SPDIF (digital coaxial/optical
audio) output. The SPDIF setting will affect whether 2-channel PCM or raw compressed bit
streams will be carried over via HDMI. When this option is selected and SPDIF is set to
“Raw”, the TV or HDMI A/V receiver must decode compressed audio formats. (Copyright
protection on some DVD-Audio and Super Audio CD discs may prevent audio output via
HDMI with this setting.)
• Off – No digital audio output via HDMI.