Onkyo DR-L50 - Manual (Page 37)

37
1
Listening to the Radio
There are two ways to select radio stations:
• Manual tuning
• Presetting radio stations then selecting the preset
channels
Unit
Tuning in a weak frequency (only for FM stations)
When you tune in a stereo FM station, the FM STEREO indicator
lights up if the signal is sufficiently strong.
If the signal is weak, you may not be able to tune to the station.
In this case, press MODE on the remote controller.
The FM STEREO indicator and AUTO goes off. Then select the
station to which you want to listen. (At this time, the station will be in
mono and interstation noise will be heard.)
3
Tuning Manually
Remote controller
Unit
Remote
controller
INPUT SELECTOR
Remote
controller
TUNING
Unit
Remote
controller
MODE
Theater-Dimensional
PROGRESSIVE SCAN
IPM
TUNING PRESET 2/3
PRESET MEMORY
INPUT 2/3
1
2
Presetting Radio Stations
You can preset up to 30 AM and FM stations.
4
Unit only
Unit
Remote
controller
TUNER PRESET
Unit only
TV/ SETUP TV/ SETUP
TEST TONE SP SETUP CH SEL
DISTANCE SW MODE UP
TV MUTING
TV
POWER
TV
INPUT
T-D SETUP IPM DOWN
TV VOL +
TV VOL -
9
TV CH - TV CH +
VOLUME
ON
STANDBY INPUT SELECTOR
RECEIVER
COND.M LAST M FUNC.M
ANGLE AUDIO SUBTITLE
T-D/ ST LATE NIGHT
TOP MENU MENU
RETURN DVD SETUP
REPEAT
TUNING TUNER PRESET
MD / CDR / TAPE
A-B STEP/ SLOW
TIMER
CLEAR
PROGRAM
SEARCH
ACOUSTIC
CONTROL
SURROUND
RANDOM
--/---
MODE
SLEEP
MUTING
DIMMER DISPLAY CLOCK
MODE
+10 0 SHIFT
9
4 5 6
7 8
1 2 3
INPUT SELECTOR 2/3
TUNER PRESET 4/¢
MODE
TUNING 1/¡
TUNING
Tune in the radio station you wish
to preset (see steps in the left
column of this page).
Press PRESET MEMORY.
The preset number starts flashing in the
display.
(Within about 8 seconds), press
TUNING/PRESET
2/3 on the unit
or TUNER PRESET 4/¢ on the
remote controller to select the
preset number.
Press PRESET MEMORY.
The radio station is registered to the
preset channel.
To register another preset station, repeat
steps 1 to 4.
Press INPUT 2/3 on the unit or
INPUT SELECTOR 2/3 on the
remote controller repeatedly to
select the band (FM or AM).
e.g. When FM is selected.
Press and hold TUNING/PRESET
2/3 on the unit or TUNING on the
remote controller for about
1 second.
• When the band is FM
Auto tuning starts. The frequency
changes in 50 kHz steps.
When a broadcast is received, scanning
stops and the frequency flashes in the
display.
• When the band is AM
The frequency changes as follows:
– (South American model)
In 10 kHz steps
– (Other models)
In 9 kHz steps
When you release the button, the frequency
stops changing and flashes in the display.
While the frequency is flashing (for
about 5 seconds), press
TUNING/PRESET
2/3 on the unit
or TUNING 1/¡ on the remote
controller to change the frequency.
• The frequency changes each time you
press the button.
• You can change the frequency as long
as the frequency in the display is
flashing. Each press of either button
causes the frequency to flash for about
5 seconds.
2
3