Onkyo 29400095 - Manual (Page 43)

43
First Time Setup
—Continued
For FM/AM tuning to work properly, you must specify
the FM/AM frequency step used in your area. Note that
when this setting is changed, all radio presets are
deleted.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
FM/AM Frequency Step Setup
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select “7. Hardware
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
3 Use the Up and Down [ ]/[ ] but-
tons to select “2. Tuner”, and
then press [ENTER].
The “Tuner” menu appears.
4 Use the Left and Right [ ]/[ ]
buttons to select:
200kHz/10kHz:
Select if 200 kHz/10 kHz steps are
used in your area.
50kHz/9kHz:
Select if 50 kHz/9 kHz steps are
used in your area.
7. Hardware Setup
1. Remote ID
2. Tuner
3. HDMI
7–2. Tuner
FM/AM Frequency Step 200kHz/10kHz
5 Press the [SETUP] button.
The setup menu closes.