Onkyo 29400095 - Manual (Page 89)

89
Controlling Other Components
—Continued
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via
, use
the following remote control codes:
• [DVD/BD] button
30627: Onkyo DVD player without (default)
• [CD] button
71817: Onkyo CD player without (default)
• [TV] button
11807:Onkyo TV (default)
If you want to control an Onkyo component by pointing
the remote controller directly at it, use the following
remote control codes:
32900: Onkyo BD player
32901: Onkyo HD-DVD player
70868: Onkyo MD recorder
71323: Onkyo CD recorder
82990: Onkyo Dock
Note:
If you connect an
-capable Onkyo RI Dock to the
TV/TAPE, VCR/DVR or GAME jacks, for to work
properly, you must set the Input Display accordingly
(see page 44).
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Onkyo
Components Connected via
1 Make sure the Onkyo component is
connected with an
cable and an
analog audio cable (RCA).
See page 36 for details.
2 Enter the appropriate remote control code
for the REMOTE MODE button.
• [DVD/BD] button
31612: Onkyo DVD player with
• [CD] button
71327: Onkyo CD player with
• [TV/TAPE] button
42157: Onkyo cassette recorder with
(default)
• [PORT] button
82351: Onkyo Dock (default)
• [TUNER] button
51805: To control the AV receiver’s tuner
(default)
See the previous page for how to enter remote
control codes.
3 Press the REMOTE MODE button, point
the remote controller at the AV receiver,
and operate the component.
Resetting REMOTE MODE Buttons
1
(3 seconds)
While holding down the REMOTE
MODE button that you want to
reset, press and hold down the
[AUDIO] button until the Remote
indicator lights up (about 3
seconds).
2 Within 30 seconds, press the
REMOTE MODE button again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
Each of the REMOTE MODE buttons
is preprogrammed with a remote con-
trol code. When a button is reset, its
preprogrammed code is restored.
Resetting the Remote Controller
1
(3 seconds)
While holding down the
[RECEIVER] button, press and
hold down the [AUDIO] button
until the Remote indicator lights
up (about 3 seconds).
2 Within 30 seconds, press the
[RECEIVER] button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.