Opticon LPN 1736 - Manual (Page 17)

Manual No. 25-ULPNMU01-01 LPN1736 Omni-Directional Laser Scanner
4. Be sure the PC is in a program or application (for example, WordPad) that will
accept input from the serial port.
Reset All Defaults -- RS-232
Our scanners are shipped with factory default settings that represent the settings most
commonly used by our customers. In most applications, the scanner will work right out
of the box without the need for additional programming.
At any time you can return the scanner back to the factory default settings by scanning
the “Reset All Defaults -RS232” programming bar code. Remember that before scanning
any programming codes, you must put the scanner into the programming mode by
scanning the Start/Stop Programming Mode bar code. You must also scan this bar code,
to exit the programming mode.
V3
(U2) Reset all Defaults
Reset All Defaults – RS232
You can also reset the scanner to the factory defaults by typing the following
sequence on the keyboard (Esc) U2 (CR)
RS-232C Communication Parameters
Handshaking Protocol
Q1
No Handshaking (P0)
DEFAULT
Page 17