Onkyo TX-SR403 - Manual (Page 30)

30
Turning On
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PHONES MULTl CH DVD VIDEO 1/VCR VIDEO 2 VIDEO 3 TAPE TUNER CD
MASTER VOLUME
A SPEAKERS B
STANDBY/ON
MUTING
MENU TOP MENU
SP A / B
--/---
TAPE/AMP
ON STANDBY
DIMMER SLEEP
INPUT SELECTOR
REMOTE MODE
V 1 V 2 V 3
C D TAPE TUNER
DVD MULTI CH
VOL
CDR
MD
DVD RECEIVER
C D
+10 0 CLR
1 2 3
4 5 6
7 8 9
CH
DISC
ON
RECEIVER
STANDBY
STANDBY indicator
Turning On the AV Receiver
1 Press the [STANDBY/ON] button.
Alternatively, press the remote controller’s [RECEIVER] button followed
by the [ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
To turn the AV receiver off, press the [STANDBY/ON] button, or the remote control-
ler’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent any
loud surprises the next time you turn on the AV receiver, always turn down the volume
before turning it off.
STANDBY/ON
Remote
controller AV receiver
or
RECEIVER
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Have you connected a component to a digital audio input?
If you have, see “Assigning Digital Inputs to Input Sources” on
page 31.
■ Have you connected an Onkyo MD recorder or CD recorder to the TAPE IN/OUT jacks?
If you have, see “Changing the TAPE/MD/CDR Display” on
page 31.
■ Do the speaker configuration—this is essential!
See “Speaker Configuration” on page 32.
OPT
COAX
OUT IN
TAPE
CD recorder / MD recorder