Onkyo HT-S590 - Manual (Page 34)

34
Turning On
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PHONES MULTl CH DVD VIDEO 1/VCR VIDEO 2 VIDEO 3 TAPE TUNER CD
MASTER VOLUME
A SPEAKERS B
STANDBY/ON
--/---
TAPE
ON/STANDBY
DIMMER SLEEP
INPUT SELECTOR
REMOTE MODE
V 1 V 2 V 3
C D TAPE TUNER
DVD MULTI CH
VOL
HDD
CDR
MD
DVD RECEIVER
C D
+10 0 CLR
1 2 3
4 5 6
7 8 9
CH
DISC ALBUM
RECEIVER
ON/STANDBY
STANDBY indicator
Turning On the AV Receiver
1 Press the [STANDBY/ON] button.
Alternatively, press the remote controller’s [RECEIVER] button followed
by the [ON/STANDBY] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
To turn the AV receiver off, press the [STANDBY/ON] button, or the remote control-
ler’s [ON/STANDBY] button. The AV receiver will enter Standby mode. To prevent
any loud surprises the next time you turn on the AV receiver, always turn down the
volume before turning it off.
STANDBY/ON
ON/STANDBY
Remote
controller AV receiver
or
RECEIVER
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Have you connected a component to a digital audio input?
If you have, see “Assigning Digital Inputs to Input Sources” on
page 35.
■ Have you connected an Onkyo MD recorder, CD recorder,
or next generation HDD-compatible component?
If you have, see “Changing the Input Display” on page 35.
OPTICAL
COAXIAL
OUT IN
TAPE
CD recorder, MD recorder
Testing the speakers
To test that all of the speakers are working properly, press the remote controller’s [TEST TONE] button.
The test tone will be output by each speaker in turn and the name of each speaker will appear on the display. To turn
off the test tone, press the [TEST TONE] button again.
• If the test tone is not produced by a speaker, or it’s produced by a speaker other than that shown on the display,
you may have wired the speakers incorrectly and you should check your connections (see page 20).
• If the test tone is not produced by a speaker and its name does not appear on the display, you may have set the
speaker settings incorrectly (see page 52).