Omega Engineering OM88128 - Manual (Page 19)

By scrolling up or down and then click OK to save the selection.
(See Dia-E )For example ,select 1,000 sample data,the logger will
stop collecting data and power off for saving battery when 1000
data collected completely .
Recording inactivated when selected data is full , and yellow LED
light will not blink to confirm operation is stopped .
SAMPLE RATE :
Select the sampling time ranges from 1 ~ 2 0 7, 0
seconds. Scroll up for increasing time seconds or down for
decreasing time in seconds. The datalogger defaults sample rate
(the length of time between each sample) as "2" though "1" is the
minimum sample rate for selecting .
Schedule -
Set up Start Date/Start Time desired to start logging. The logger
will start when the setting time clock reaches the time you entered.
Make sure the logger date and time are the time you are now .
Magnetic -
Link with your computer to setup the Magnetic start mode , select
Magnetic , make sure the logger date and time are the time you are
now , press "OK" , enter desired ID , press"OK" To confirm the
Magnetic start setting .
Immediate -
While pressing "OK" Button , the logger starts recording immediately.
FAQ: If I want to stop logging before completing all sample
points , how should I do ?
Ans: Download with computer to stop logging.
Note: The download operation before completing all sample
points won't work for the logger sample rate to be set
as "1" second .
START MODES :
(Diagram F):
16