Orion 52084 User Manual
Page 44
44
the “Found new Hardware Wizard” appears again when
the camera is plugged into a different uSB port for the
first time.
This is normal.
Most USB controllers behave this way. Every time the camera is plugged
into a different USB port for the first time, the drivers will have to be rein-
stalled. Since the drivers were previously installed on your computer, you
do not need the CD when installing the camera on a new USB port.
Note that external USB hubs will behave the same way.
Every time the camera is plugged into a different USB port on the hub, the
“Found New Hardware Wizard” will appear again.
Windows Vista should automatically install the drivers on different USB ports
without prompting you to take any action.
there are several short horizontal lines or there is
irregular noise throughout the image.
You are likely experiencing readout noise as a result of running the camera too
fast for your computer
(Figure 25).
The camera has 8 speed settings, listed 1-8 (default is 5). The higher the
speed setting, the faster the image will download. Higher speed settings
require faster processors.
If you do not see any short horizontal lines in your images, you can try
increasing the readout speed one or two points. To make an adjustment,
click on Setup in the Camera Control Window. Click the up/down
arrows to change the speed setting (Figure 26). The minimum is 1; the
maximum is 8.
Figure 25.
Readout artifacts similar to the ones shown here can occur if the camera
readout speed is set too fast for your computer.
Figure 26.
Select the fastest possible readout speed (between 1 and 8) that
downloads an image without any artifacts.
25.
26.