One for All URC3050 - Manual (Page 2)

Step 1:
Installing the Batteries
Step 3:
Setting Up Your Devices
1
1
2 Match the batteries to the + and - marks inside
the battery case, then insert the batteries.
3 Press the battery cover back into place.
1st TV code
2nd TV code
3rd TV code
1st VCR code
2nd VCR code
3rd VCR code
1st Cable code
2nd Cable code
3rd Cable Code
Step 2:
Looking Up Your Electronic Device Code
You will need o ne of these codes to program your One For All ® So
Easy 3 Device remote.
Look at your Electronic Device to find out the brand name and
write it in the space below:
TV ________________________
VCR _______________________
Cable _______________________
1
2
Your One For All ® So Easy 3 Device needs two (2) new AAA
alkaline batteries. To install the batteries:
On the back of the One For All ® So Easy 3
Device , push down on the tab and lift the
cover off.
Set-Up Codes
RCA 1213
Sony 1111
Turn on your TV, VCR or Cable Box, depending on the
device you are programming.
2 Press TV* and release. Press and hold SETUP
until the One For All
® So Easy 3 Device's red
light blinks twice. Release SETUP.
* Note: When setting up your VCR and/or Cable Box,
substitute the appropriate device key (VCR or CBL).
3 Using the example
shown on the
right, enter the
first four-digit
code you wrote
down for the
device you are
setting up. (See
"Looking Up Your
Electronic Device
Code".) If you put
in the code
correctly, the red
light will blink
twice.
4 Test the unit by pressing POWER. The red
light (LED) should blink once.
Note: Removing the batteries for more than 30 minutes will require you to
reprogram the remote control.
+
Find your Device brand in the listing on the
reverse side of these instructions. The most
popular codes are listed first. Write your codes
here:
How to Enter Codes
If your TV Press
code is:
1
2
3
4
TV Set Up
Aim the One For All ® So Easy3 Device at your
TV and press POWER. Your TV should turn off.
If it doesn't, repeat Steps 2-4, trying each code listed
for your brand until you find the one that operates
your TV.
VCR Set Up
Aim the One For All ® So Easy3 Device at your
VCR and press POWER. Your VCR should turn
off. If it doesn't, repeat Steps 2-4, trying each code
listed for your brand until you find the one that
operates your VCR. If your original VCR remote
did not have a POWER key, put a tape in your
VCR and press PLAY on the One For All
® So
Easy3 Device.
Cable Set Up
Aim the One For All ® So Easy 3 Device at your
Cable Box and press POWER. Your Cable Box
should turn off. If it doesn't, repeat Steps 2-4, trying
each code listed for your brand until you find the
one that operates your Cable Box. If your original
Cable Box remote did not have a "ON" key, Use
CH + on the One For All
® So Easy 3 Device to
turn your Cable Box on.
4
or
or