Onkyo HT-R518 - Manual (Page 60)

60
Advanced Setup —Continued
Note:
• These settings cannot be changed while headphones
are connected or the multichannel DVD input is being
used.
Crossover Frequency
This setting only applies to the speakers that you speci-
fied as
Small in the “Speaker Configuration” on page 59.
To get the best bass performance from your speaker sys-
tem, you need to set the crossover frequency according
to the size and frequency response of your speakers
Notes:
• For a more accurate setting, look up the frequency
response in the manuals supplied with your speakers
and set accordingly.
• Choose a higher crossover frequency if you want more
sound from your subwoofer.
• These settings cannot be changed while headphones
are connected or the multichannel DVD input is being
used.
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left, right, and
center to the subwoofer. This function can be set only if
the Subwoofer setting (step 3) is set to Yes, and the Front
setting (step 4) is set to Large in the Speaker Configura-
tion on page 59.
Note:
• These settings cannot be changed while headphones
are connected or the multichannel DVD input is being
used.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.
Continue with step 7 of the “Crossover
Frequency” setting.
7 Use the Down [ ] button to
select “Crossover,” and then use
the Left and Right [
]/[ ] but-
tons to select a crossover fre-
quency.
Use the diameter of the smallest
speaker in your system when choosing
the crossover frequency.
*Choose the setting suitable for the speaker.
Continue with step 8 of the “Double
Bass” setting on the right column.
This setting is set automatically by the Automatic
Speaker Setup function (see page 34).
Speaker cone
diameter
Crossover
frequency
Over 8 in.
(20 cm)
40/50/60Hz*
6-1/2 to 8 in.
(16–20 cm)
80Hz
5-1/4 to 6-1/2 in.
(13–16 cm)
100Hz (default)
3-1/2 to 5-1/4 in.
(9–13 cm)
120Hz
Under 3-1/2 in.
(9 cm)
150/200Hz*
8 Use the Down [ ] button to
select “Double Bass,” and then
use the Left and Right [
]/[ ]
buttons to select:
On: Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
Off: Double Bass function off.
9 Press the [SETUP] button.
Setup closes.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 34).
HT-R518_En.book Page 60 Tuesday, March 11, 2008 11:31 AM