Onkyo TX-NR1007 - Manual (Page 52)

52
First Time Setup
—Continued
If you connect a component to the AV receiver’s analog
multichannel input, you must assign that input to an
input selector. For example, if you connect your DVD/
BD player to the MULTI CH input, you must assign it to
the DVD/BD input selector.
Notes:
• To listen to the component connected to the multi-
channel input, press the [AUDIO] button and select
the “Audio selector” (see page 114).
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
Analog Audio Input Setup
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down []/[ ] but-
tons to select “1. Input/Output
Assign”, and then press
[ENTER].
The “Input/Output Assign” menu
appears.
3 Use the Up and Down []/[ ] but-
tons to select “5. Analog Audio
Input”, and then press [ENTER].
The “Analog Audio Input” menu
appears.
4 Use the Left and Right []/[ ]
buttons to select an input selec-
tor.
You can assign the multichannel input
to the following input selectors: “DVD/
BD”, “VCR/DVR”, “CBL/SAT”,
“GAME”, “AUX”, “TV/TAPE”, “CD”,
or “PHONO”. If you don’t want to
assign the multichannel input, set to
“- - - - -”.
1. Input/Output Assign
1. Monitor Out
2. HDMI Input
3. Component Video Input
4. Digital Audio Input
5. Analog Audio Input
Multich
Subwoofer Input Sensitivity
1–5. Analog Audio Input
- - - - -
5 Press the [SETUP] button.
The setup menu closes.