Onkyo TX-NR1007 - Manual (Page 65)

65
Basic Operations
—Continued
You can select the priority of the use of Front High
speakers or Front Wide speakers.
Notes:
• If the Powered Zone 2 is being used (page 127), this
setting cannot be selected.
• When the listening mode that doesn’t support Front
High or Front Wide speakers is used, the setting can-
not be selected.
• If you use surround back speakers, the speaker selec-
tion will be based on the combination of surround
back and front high speakers, or surround back and
front wide speakers.
You can connect a pair of stereo headphones (1/4-inch
phone plug) to the AV receiver’s PHONES jack for pri-
vate listening, as shown.
Notes:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the PHONES
jack, the Headphone indicator, speaker/channel indi-
cator FL and FR light up. (The Powered Zone 2/3
speakers are not turned off.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it’s already set to Stereo,
Mono, Direct, Pure Audio or DTS Surround Sensa-
tion.
• Listening mode automatically changes into DTS sur-
round sensation when you connect a pair of head-
phones while DTS surround sensation mode is
currently selected.
• The following listening modes can be used with head-
phones (the listening modes available also depend on
the currently selected input source): Stereo, Direct,
Pure Audio, Mono and DTS Surround Sensation.
Selecting Speaker Layout
Remote
controller
Press the [RECEIVER] button,
and then press the [SP LAYOUT]
button repeatedly to select:
FrontHigh or FrontWide.
FrontHigh:
The sound from front high speakers
is output by priority.
FrontWide:
The sound from front wide speakers
is output by priority.
Using Headphones