Onkyo TX-SR573 - Manual (Page 28)

28
Connecting Your Components—Continued
• With connection , you can play and record with the recorder and listen via speaker set B.
• To connect the recorder digitally (playback only), use connections and , or and .
The AV receiver has an AC outlet on its rear panel for
connecting the power cord of another AV component.
The other component’s power switch can then be left in
the ON position so that it turns on or off when the AV
receiver is set to On or Standby.
Caution:
• Make sure that the capacity of the component that
you connect to the AC OUTLET does not exceed
the stated capacity (e.g., 120 W).
Note:
• Onkyo components connected via should be
connected directly to a wall outlet, not the AV
receiver’s AC OUTLET.
Connecting a Cassette, CDR, MiniDisc, or DAT Recorder
Connection AV receiver Signal flow Cassette/CDR/MD/DAT recorder
TAPE IN L/R
TAPE OUT L/R
⇐
⇒
Analog audio L/R output
Analog audio L/R input
DIGITAL IN COAXIAL
⇐
Digital coaxial output
DIGITAL IN OPTICAL 3
⇐
Digital optical output
Connecting Another Component’s Power Cord
OUT
REC PLAY
IN OUT
L
R
L
R
IN
TAPE
L
R
OPTICAL
3
OPTICAL
OUT
DIGITAL IN
COAXIAL
COAXIAL
OUT
Step 1:
Choose a connection that matches the recorder (
, , or ), and then make the connection. a b c
a
b
c
Cassette recorder, CDR,
etc.
Connect one
or the other
a
a b a c
a
b
c