Onkyo AV RECEIVER TX-NR1009 - Manual (Page 42)

42
En
You can set which speakers you want to use by priority.
You can temporarily mute the output of the AV receiver.
Selecting Speaker Layout
1 Press RECEIVER followed by SP LAYOUT
repeatedly to select:
■
9.1 ch playback
`
Speaker Layout:SB/FH
The sounds from surround back and front high
speakers are output by priority.
`
Speaker Layout:SB/FW
The sounds from surround back and front wide
speakers are output by priority.
`
Speaker Layout:FH/FW
The sounds from front high and front wide
speakers are output by priority.
Note
• If the “Speakers Type(Front)” setting is set to “Bi-Amp”
(
➔
page 47), or the “Powered Zone 2” is set to “Yes”
( ➔ page 47), this setting cannot be selected.
• Playback conditions may be limited depending on the set-
tings in “Speaker Settings” (
➔ page 47) and
“Speaker Configuration” (
➔
page 48).
• When a listening mode which doesn’t support front high,
front wide or surround back speakers is used, this setting
cannot be selected.
Muting the AV Receiver
1 Press RECEIVER followed by MUTING.
The output is muted and the MUTING indicator
flashes on the display.
Tip
• To unmute, press MUTING again or adjust the volume.
• Muting is automatically cancelled when the AV receiver is
set to standby.
Using Headphones
1 Connect a pair of stereo headphones with a
standard plug (1/4 inch or 6.3 mm) to the
PHONES jack.
Note
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the PHONES
jack, the speakers are turned off. (The Powered Zone 2/3
speakers are not turned off.)
• When you connect a pair of headphones, the listening mode
is set to Stereo, unless it’s already set to Stereo, Mono,
Direct, or Pure Audio.
• If you connect an iPod or iPhone to the USB port on this
device, no sound will be output from the headphones jack.