Opticon LPR5627 - Manual (Page 56)

Manual No. 25-ULPNR101-03; Feb, 2003 LPN5627 / LPR5627 Laser Fixed Mount
Scanner
Page 52
22. Positive & Negative Bar Codes
Computer
Command
Function
/Description
Bar Code
Command
(Z7)
START/END
Programming Menu
-[8-
V4
Positive bar code only
(black bars/white spaces)
-W3-
V2
Both positive & negative bar
code
-W5- %
23. Setting the Trigger Function
Computer
Command
Function
/Description
Bar Code
Command
(Z7)
START/END
Programming Menu
-[8-
S7
Disable the trigger function
/ Red scanning light is ON
continuously (Factory Set)
-T8-
S8
Enable the trigger function /Red
scanning light is OFF until trigger
is activated or “pulled”
-T9- %
Z
Activate the trigger; turns on the
red scanning light
Use
Computer Command
The Trigger function is disabled in the default setting. This means that the red scanning light is “ON”
continuously and the scanner is always ready to read. For some applications, you may wish to activate
the scanner only at a specific time. This can be done by enabling the Trigger function. Once in the
“Trigger Enabled” mode, the red scanning light is OFF until the trigger is activated or “pulled.” Either a
hardware trigger or a software trigger pulse may be used to activate the scanner.
The hardware trigger is actuated by pulling Pin #1 (on the standard 9-pin mini-DIN connector) LOW.
The software trigger is actuated by downloading and <ESC> Z <CR> computer command from the host.
(See Scanner Timeout to establish the length of time the scanning light remains ON after the trigger is
activated.)