Connecting an onkyo cd recorder (cr515), Connecting a portable audio device, Connecting an onkyo cd recorder – Onkyo CR-515 CR-315 User Manual
Page 23: Cr-515), K (cr-515) (23), K (cr-315) (23), Connecting other components —continued
23
Connecting Other Components—Continued
The following diagram shows how to connect an optional Onkyo CD recorder.
Connect the CD receiver’s DOCK/CDR OUT jacks to the CD recorder’s INPUT (REC) jacks, and connect the CD
receiver’s DOCK/CDR IN jacks to the CD recorder’s OUTPUT (PLAY) jacks.
What can you do with
?
• Connecting an Onkyo CD recorder to the CD receiver with an
cable allows you to control the CD recorder with
the CD receiver’s remote controller. In addition, when playback is started on the CD recorder, the CD receiver will
automatically select it as the input source.
• To use
, you must connect the Onkyo CD recorder to the CD receiver with an
cable and an analog audio cable
(RCA). In addition, the Input Display for the DOCK/CDR jacks must be set to “CDR” (see page 29).
• Some
-capable components have two
jacks. They’re both the same, so you can use either one. The extra jack
is for connecting additional
-capable components.
The following diagram shows how to connect a portable audio device (e.g., MP3 player, MD player, CD player).
Connect the CD receiver’s LINE 2 IN jack (LINE IN jack on the CR-315) on the front panel to the portable audio
device’s output jack.
Depending on the type of output jack on the portable audio device, you may need to buy a suitable cable. The CD
receiver’s LINE 2 IN jack (LINE IN jack on the CR-315) accepts a stereo miniplug.
Notes:
• Use a connecting cable that doesn’t have any attenuation resistors in it.
• If you connect a portable audio device’s headphone output to the CD receiver’s LINE2 IN jack (LINE IN jack on the
CR-315), turn down the volume on the portable audio device before you connect it.
• When you connect a portable audio device to the CD receiver, make sure you connect it to the LINE 2 IN jack (LINE
IN jack on the CR-315) and not the adjacent PHONES jack. If you connect to the PHONES jack by mistake, it may
cause the PHONES output to malfunction.
Connecting an Onkyo CD Recorder (CR-515)
Connecting a Portable Audio Device
I N
I N
R
LINE 1
MD/
TAPE
L
I N
OUT
OUT
DOCK/
CDR
(REC)
(PLAY)
INPUT
OUTPUT
REMOTE
CONTROL
L
R
: Signal flow
Onkyo CD recorder’s
rear panel
Analog audio cable (RCA)
cable supplied with
the Onkyo CD recorder
White
Red
White
Red
Red
Red
White
White
CR-515’s rear panel
: Signal flow
CR-515’s front panel
Stereo miniplug cable
Portable audio device’s output jack