Onkyo A-933 - Manual (Page 12)

12
Connecting the A-933 —Continued
Connecting the Speaker Cables
The following illustration shows which speaker should
be connected to each pair of terminals.
You can connect a subwoofer with a built-in power
amplifier to the A-933’s SUBWOOFER PREOUT jack.
Tip: The volume and quality of the bass output from
your subwoofer will depend on its position, the shape of
your listening room, and your listening position. In gen-
eral, a good bass sound can be obtained by installing the
subwoofer in a front corner, or at one-third of the way
along the wall in front of your listening position. To find
the best position for your subwoofer, while playing a
movie or some music with good bass, experiment by
placing your subwoofer at various positions within the
room, and choose the one that provides the most satisfy-
ing results.
1 Strip about 15 mm of insu-
lation from the ends of the
speaker cables, and twist
the bare wires tightly, as
shown.
2 Unscrew the terminal.
3 Fully insert the bare
wires.
4 Screw the terminal tight.
15 mm
AC OUTLET
UNSWITCHED
TOTAL 100W MAX.
AC 230-240 V
50 Hz
CAUTION: SPEAKER IMPEDANCE
A or B : 4 OHMS MIN. /SPEAKER A + B : 8 OHMS MIN. /SPEAKER MODEL NO. A- 933 INTEGRATED AMPLIFIER
MD
SPEAKERS
R
R
L
R
L
L
R
L
R
L
OUT IN OUT IN REMOTE CONTROL TAPE/CDR MAIN IN
CD LINE TUNER ONO (MM)
A B
R L R L
R
L
SPEAKERS A B
R L R L
+ –
+ – + –
+ –
A-933
Speaker set A
Left
speaker
Right
speaker Speaker set B
Left
speaker
Right
speaker
Connecting a Subwoofer
AC OUTLET
UNSWITCHED TOTAL 100W MAX.
AC 230-240 V 50 Hz
CAUTION: SPEAKER IMPEDANCE A or B : 4 OHMS MIN. /SPEAKER A + B : 8 OHMS MIN. /SPEAKER MODEL NO. A- 933 INTEGRATED AMPLIFIER
MD
SPEAKERS
R
R
L
R
L
L
R
L
R
L
SUBWOOFER
PREOUT
OUT IN OUT IN
GND
REMOTE CONTROL TAPE/CDR MAIN IN
CD LINE TUNER PHONO (MM)
A B
R L R L
R
L
SUBWOOFER
PREOUT
LINE INPUT
LINE INPUT
SUBWOOFER
PRE OUT