Onkyo A-5VL - Manual (Page 16)

Enjoying Audio Sources (Operating the Unit) —Continued
16
Adjusting the Tone and Left/Right
Volume Balance
Press the DIRECT button on the front of the
unit to turn it off.
DIRECT off: Audio adjusted via the unit's
BASS, TREBLE, and BALANCE
controls is output.
DIRECT on: Audio is output directly, without
passing through the BASS,
TREBLE, and BALANCE tone
control circuits.
Turn the BASS control to adjust the bass.
Turn the TREBLE control to adjust the treble.
Turn the BALANCE control to adjust the
volume balance output from the left and right
speakers.
Notes
- Turn the BASS and TREBLE controls to the right to increase
the bass and treble, respectively.
- Although you can adjust the left and right volume using the
BALANCE control, turning it all the way to the right or left
will only reduce the volume from that speaker; it will not set
the volume to zero.
- The controls should normally be kept in the center position.
Recording
This section describes how to record audio when both a
playback component and recording component are
connected to the unit.
Notes
Manual tone adjustments using the BASS, TREBLE, and
BALANCE controls are not reflected.
Caution
Unless you have the full consent of the copyright holder,
copyright laws prohibit using your recordings for anything
other than personal enjoyment!
Turn the input selector control on the front of
the unit to select the audio playback
component.
Place the recording component into recording
standby.
Notes
See the manual of the recording component for instructions on
correct use.
Start playback on the playback component.
Start recording on the recording component.
Caution
Do not move the unit's input selector while recording. Doing
so will cause the audio from the selected component to be
recorded.