Onkyo AV Receiver TX-NR509 - Manual (Page 11)

11
En
Connections
Connecting the AV Receiver
Connecting the Speaker Cables
The following illustration shows which speaker should be connected to each pair of terminals. If you’re using only one
surround back speaker, connect it to the SURROUND BACK L PRE OUT jack.
Connect your Power amplifier’s analog audio input jacks to the AV receiver’s SURROUND BACK L/R PRE OUT
jacks with audio cables.
■ Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of insulation from
the ends of the speaker cables, and twist the bare
wires tightly, as shown.
■
Banana Plugs (North American models)
• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center hole of the speaker terminal.
Connecting Your Speakers
AUDIO
INPUT
L R
Front left Center
Surround
right
Front right
Surround
back right
Surround
back left
Surround
left
Power amplifier
1/2" to 5/8" (12 to 15 mm)