Oregon WRS368 User Manual
Page 11
EN
10
TIP
TIP
TIP
LEARNING TO ACTIVATE THE MUTE FUNCTION
USING THE AUDIO SOURCE REMOTE CONTROL
DEVICE
To teach your remote control device to activate the Mute
function:
1. Press the
button 3 times or once if you were
previously learning to decrease volume.
and
will appear flashing simultaneously on the LCD
for 3 seconds.
will remain flashing while
will flash in place of
.
2. Press the mute button on the remote control device
of your audio source while pointing the remote control
device at the speaker.
stops flashing once a
signal is received.
then appears and begin
flashing, indicating that the remote control device
has confirmed learning the function.
3. Press the button once to exit the Learning mode.
The mute button of your remote control device has now
learned to activate or deactivate the mute function on
your Wireless Remote Speaker when pressed.
You can repeat these steps with any of the 3 audio
sources but you must use the remote control device of
the particular audio source. For example, you can only
use the remote control device of audio source
to
adjust audio source
volume and mute, not audio
source
.
After the remote control device has successfully
learned to increase, decrease and mute speaker volume,
you no longer need to point the remote control device
38 mm (1.5 inches) from the speaker; instead, you may
use the remote control device to increase volume up to
7 meters (23 feet) in open space away from the speaker.
THE REMOTE REPEAT FUNCTION
With the Remote Repeat function, you can adjust the
numerous audio source functions using its remote control
device, such as fast-forward, rewind, repeat, play, stop,
pause, and so on - right from the speaker. There is no
need to go to the audio source to control these functions
because you can simply point its remote control device
toward the speaker and control the functions.
For example, you may have 2 audio sources - a DVD
player and a TV - connected to the Wireless Remote
Speaker and both are located in the living room, while
the speaker is located in a bedroom. From the bedroom,
you can:
•
Point the DVD player's remote control device at the
Wireless Remote Speaker's infrared sensor to fast-
forward to a movie scene on the DVD or repeat a
certain scene.
•
Point the TV remote control device at the speaker
and press the corresponding button to change the
TV channel.
The distance between remote control device and
speaker should be no more than approximately 38 mm
(1.5 inches) apart. This is to ensure the infrared signal
from the audio source's remote control device is captured
by the Wireless Remote Speaker during the learning
session.
3. On the speaker, press the
button once.
and
will appear flashing simultaneously on the LCD
for 3 seconds.
will remain flashing while
will
flash in place of
.
4. Press the volume up button on the remote control
device of your audio source while pointing the remote
control device at the speaker.
stops flashing
once a signal is received.
then appears and
begins flashing, indicating that the remote control
device has confirmed learning the function.
5. Press the button 3 times to exit the Learning mode,
or press once to learn to decrease volume.
The volume up button of your remote control device has
now learned to increase the volume on your Wireless
Remote Speaker when pressed.
LEARNING TO DECREASE VOLUME USING THE
AUDIO SOURCE REMOTE CONTROL DEVICE
To teach your remote control device to decrease volume:
1. Press the
button twice or once if you previously
learned to increase volume.
and
will
appear flashing simultaneously on the LCD for
3 seconds.
will remain flashing while
will flash in place of
.
2. Press the volume down button on the remote control
device of your audio source while pointing the remote
control device at the speaker.
stops flashing
once a signal is received.
then appears and
begins flashing, indicating that the remote control
device has confirmed learning the function.
3. Press the
button 2 times to exit, or press once to
learn to mute the volume.
The volume down button of your remote control device
has now learned to decrease the volume on your
Wireless Remote Speaker when pressed.
WRS368 Eng (US) R18 OP
7/30/05, 10:51 AM
10