Olivetti 503206 - Manual (Page 14)

CHAPTER 1 10
Loading Different Types of Paper
TURNING YOUR PRINTER ON AND OFF
Turning On Your Printer
Press the ON/OFF button on the right of the front panel.
note: Before pressing the ON/OFF button, make sure that the printer’s power cord is plugged into a
grounded electrical outlet. See the Setup Diagram, included in the printer’s box, for information on
how to setup your printer.
After pressing the ON/OFF button, the printer executes a series of autodiagnostic tests aimed at
detecting any possible system malfunction. Any error detected at this time will be signalled by the front
panel, or by the personal computer if connected to the printer. See "Meaning of the LED Indicators on
the Front Panel" for the corrective actions in case any error is detected.
Upon the successful completion of the autodiagnostic phase, certain buttons on the front panel will
illuminate to indicate the functions that are available according to the current printer configuration
(whether or not it is connected to a computer or to a digital camera).
When the printer is not connected to a computer, the following indicators or buttons are
illuminated:
To load: Proceed as follows:
Plain paper, coated
paper, glossy paper,
photo paper,
greeting cards,
index cards, post
cards, envelopes,
transparencies,
ink-jet labels • Load the media vertically against the right side of the paper support and with
the print side facing up.
• Squeeze and slide the paper guide against the left edge of the paper.
note: Load letterhead paper with the top of the letterhead entering the printer
first and facing up.
Banner paper • Remove all paper from the paper support.
• Insert the leading edge of the banner paper vertically into the printer against
the right side of the paper support and with the print side facing up.
note: Do not use perforated fan-fold banner paper.
•
Squeeze and slide the paper guide against the left edge of the banner paper.
Iron-on T-shirt
transfers • Read the instructions on the transfer package.
• Load the blank side of the iron-on transfer vertically against the right side of
the paper support and facing up.
• Squeeze and slide the paper guide against the left edge of the transfer.