Outlaw Audio 1070 - Manual (Page 50)

50 Outlaw Audio
Owner’s Manual
Listed below are some of the more common issues you could encounter. For
additional hints on using the Model 1070 or resolving problems we suggest that
you look at the Model 1070 section of our website at www.outlawaudio.com, or
enter the Model 1070 Section of our Outlaw Saloon. If your problem persists,
please call us at 866-OUTLAWS (688-5297) or 866-OUTLAWA (688-5292).
Troubleshootong
TroubIeshooting
Your new Model 1070 is designed to provide years of trouble-free operation.
However, the complexity of today’s sophisticated home theater systems means
that you might encounter an occasional problem with your system involving
the Model 1070.
Symptom Possible Cause Solution Options
Unit does not turn on when remote or
front panel buttons are pressed
No AC Power Make certain AC power cord is plugged into a live outlet
Make certain rear panel MAIN POWER switch is ON
No sound from digital audio source Input not properly selected Make certain the correct digital input is associated to the source
No DTS when a DVD is playing Incorrect bitstream output from DVD player Check the DVD player’s setup menus to make certain DTS output is selected
Check the disc menu to make certain DTS is selected
No sound from rear surround speakers Incorrect speaker configuration Check Speaker Configuration menu to make certain that surround speakers are set to “small”
or “large”
Intermittent buzzing in tuner Interference from local sources Move or relocate the antenna
Move the antenna or unit away from computers, fluorescent or neon lights, or appliances
with motors
Unit does not respond to remote
commands
Low remote battery power
Remote set to different device
Remote sensor is obscured Change the batteries
Press the TNR button to make sure the remote is outputting 990 codes
Make certain the front-panel remote sensor is not blocked or connect an external remote
sensor
No sound from one or more channels Poor connections
Incorrect surround mode
Incorrect speaker configuration Check interconnects to the amplifier and connections from the amplifier to the speakers
Check surround mode to make certain it provides output to all speakers
Check Speaker Configuration menu to make certain all speakers are set to “small” or “large”