Optimus STAV-3690 - Manual (Page 26)

26
Using the Remote Control
Follow these steps to train the STAV-3690’s remote control.
1. Place both controls 1–2 inches apart with the windows facing each other.
2. Select the AUDIO/VIDEO switch position. Set the switch to the position that
best matches the function — to AUDIO for a CD player or tape deck or to
VIDEO for a VCR or television.
3. Insert a pointed object (such as a straightened paper clip or the tip of a
pen) into the LEARN hole on the STAV-3690’s remote control, then press
and release. The TRANSMIT/ LEARN indicator flashes.
4. Within 1 minute, press the STAV-3690’s remote button you want to train.
The TRANSMIT/LEARN indicator lights steadily.
5. Within 1 minute, hold down the other device’s remote control button that
you want the STAV-3690’s remote to learn. The TRANSMIT/ LEARN indi-
cator flashes.
If TRANSMIT/LEARN flashes twice, the signal might be too weak. Place
the remote controls closer together and try again.
If TRANSMIT/LEARN repeatedly flashes, the remote control’s memory is
full. Programming errors can fill memory. For example, fluorescent light,
direct sunlight, the two remote controls being too far apart, or a low bat-
tery might cause this error. Correct the error and try again.
6. Repeat Steps 4 and 5 to teach additional commands.
7. To exit the teaching mode, press LEARN or wait 1 minute.
To clear all learned commands from memory, press RECEIVER POWER , CD POW-
ER , and TAPE/VCR POWER at the same time. The TRANSMIT/LEARN indicator flash-
es four times.
1–2''