Omron Healthcare COMPAIV XLT NE-C25 - Manual (Page 15)

15
USING THE DEVICE
5. At the end of the treatment, turn the power switch off. The power
switch is in the position. The compressor turns off and
nebulization stops.
6. Disconnect the Air Tubing from the Nebulizer Kit. Grasp the end of the
Air Tubing connected to the nebulizer kit and gently pull down to
disconnect the Air Tubing from the Air Tubing Connector on the
bottom of the nebulizer kit.
7. Check the Air Tubing. No condensation or moisture should remain in
the Air Tubing.
WARNING
Do not store the air tubing with moisture or medication remaining in the air
tubing. This could result in infection as a result of bacteria.
If any condensation or moisture remains in the air tubing, remove the
moisture from the air tubing. Follow the directions below:
1. Make sure the Air Tubing is still connected to the Air connector
on the front side of the compressor.
2. Turn the power switch on. The power switch is in the (1)
position. The compressor will start and pump air through the
air tubing to expel the moisture.
3. Turn the power switch off.
8. Disconnect the Air Tubing from the compressor. Grasp the end of the
Air Tubing and gently pull the Air Tubing off the Air Connector on the
front side of the compressor.
9. Unplug the device from the electrical outlet.
CAUTION
Unplug the power cord from the electrical outlet after
using the device.
AC100V
272145 NE-C25-all 11/5/07 2:28 PM Page 15