Orion Car Audio 200 - Manual (Page 30)

4-CHANNEL AMPLIFIER INPUT CONFIGURATIONS
The 2-channel input / 4-channel input switch routes RCA input from the front RCA inputs to the rear section of the amplifier. This allows the
XTREME 4-channel amplifier to utilize a single set of RCAs to feed signal to both the front and rear channels of the amplifier.
When the switch is in engaged, signal from the front RCA input is routed to the rear RCA inputs.
NOTE: In this configuration, the rear RCA inputs can be routed to another amplifier. The signal leaving the amplifier
is a copy of the incoming signal.
When the switch is disengaged, front and rear RCA inputs are independent. This allows a source unit with an
internal fader to fade between the front and rear outputs.
INTERNAL CROSSOVER CONFIGURATION
The XTREME 200 and 400.4 amplifiers use multi-position switches to determine their crossover configurations. The multi-position switch (dual
switches on the XTREME 400.4) is located on the adjustment side of the amplifier. Listed below are the switch positions and their respective
crossover configurations. NOTE: On 4-channel amplifiers, the front and rear crossover settings are independently adjusted.
When the switch is in the “OFF” position, the crossover section of the amplifier is bypassed. Amplifier output is full
range.
When the switch is in the center position, the crossover is configured for high-pass operation.XTREME amplifiers
have a fixed frequency crossover set to 100Hz at 12dB/octave.
page 28