Onkyo TX-SR8350 - Manual (Page 30)

30
Turning On
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PURE AUDIO PHONES MULTl CH DVD VIDEO 1 VIDEO 2
VCR
VIDEO 3 TAPE TUNER CD VIDEO
VIDEO 3 INPUT
AUDIO L R
MASTER VOLUME
A SPEAKERS B
STANDBY/ON
MUTING
PREVIOUS
MENU
GUIDE
TOP MENU
SP A / B
--/---
TAPE/AMP
M D
CDR
CABLE
ON STANDBY
DIMMER SLEEP
10 11 12
INPUT SELECTOR
REMOTE MODE
V 1 V 2 V 3
CD TAPE TUNER
DVD MULTI CH
T V VOL VOL
SAT
VCR
T V
DVD RECEIVER
CD
INPUT
+10 0 CLR
1 2 3
4 5 6
7 8 9
CH
DISC
ON
RECEIVER
STANDBY
STANDBY indicator
Turning On the AV Receiver
1 Press the [STANDBY/ON] button.
Alternatively, press the remote controller’s [RECEIVER] button followed
by the [ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
To turn the AV receiver off, press the [STANDBY/ON] button, or the remote control-
ler’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent any
loud surprises the next time you turn on the AV receiver, always turn down the volume
before turning it off.
STANDBY/ON
Remote
controller AV receiver
or
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.
■ Have you connected a component to a digital audio input?
If you have, see “Assigning Digital Inputs to Input Sources” on
page 31.
■ Have you connected an Onkyo MD recorder or CD recorder to the TAPE IN/OUT jacks?
If you have, see “Changing the TAPE/MD/CDR Display” on
page 31.
■ Have you connected any speakers with an impedance of between 4 and 6 ohms?
If you have, see “Minimum Speaker Impedance Setup” on page 32.
(Not North American models.)
■ Do the speaker configuration—this is essential!
See “Speaker Configuration” on page 32.
OPT1
COAX
OUT IN
TAPE
CD recorder / MD recorder
Speaker
4
Ω – 6Ω