Ohlins FG 670 - Manual (Page 13)

7.
Apply some front fork oil (1311-01) to the
inner tube surface and carefully mount the
outer tube (slide it completely down).
! WARNING!
Be careful not to damage the fork seal!
8.
Fill up with Öhlins front fork oil (1311-01) all
the way to the edge of the reservoir. Con-
tinue to fill until the oil level is the same in
both the reservoir and in the cylinder tube.
9.
Push the gas piston, with teflon band
and O-ring fitted, to the reservoir bottom
without allowing it to be pressed back over
the circlip groove, make sure that there is
no air between the piston and the oil. Use
tool 720-02.
Close the compression adjuster.
9
! WA
RNING!
8 7
Tool 720-02
13
1675-01, Nut 1674-01, W
asher
Clamp Comp. Shim stack Comp. 1670-01, Piston 338-11, O-ring 530-22, Shims 1693-01, Spring 1669-01, Sleeve 1672-01, Collar 1658-01, End piece 438-02, O-ring 1242-09, Needle 1474-01, Spring 884-02 x 2, Ball 338-53, O-ring
1658-03, End piece
Basevalve RIGHT side (rebound leg)
Basevalve LEFT side (compression leg)
438-02, End piece
1672-01, Collar 1669-01, Sleeve 1693-01, Spring 530-22, Shims 338-11, O-ring 1670-01, Piston Shim stack Comp. Clamp Comp. 1674-01, W
asher
1675-01, Nut 4803-11 (3 Nm , loctite 243)