Onkyo 29344937 - Manual (Page 82)

82
Zone 2
—Continued
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
Notes:
• Only analog input sources are output by Zone 2.
Digital input sources are not output. If no sound is
heard when an input source is selected, check to make
sure it’s connected to an analog input.
• While Zone 2 is on, the Auto Power On/Standby and
Direct Change functions do not work.
• While Powered Zone 2 is being used, listening modes
that require surround back or front high speakers
(6.1/7.1), such as Dolby Digital EX, DTS-ES and
Dolby Pro Logic IIz Height are unavailable.
• When the “Powered Zone 2” setting is set to “Act” and
the input selector of Zone 2 is selected, power
consumption on standby mode slightly increases.
Controlling Zone 2 with the Remote
Controller
Note:
To control Zone 2, you must press the remote
controller’s [ZONE 2] button first.
Using Zone 2
1 To turn on Zone 2 and select an
input source, press the [ZONE 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on and ZONE 2 indicator
lights up.
To select the same source as that of the
main room, press the [ZONE 2] button
repeatedly until “Z2 Sel: Source”
appears.
To select AM or FM press the
[TUNER] input selector button
repeatedly.
Note:
You cannot select different AM or FM
radio stations for your main room,
Zone 2. The same AM/FM radio station
will be heard in each room.
2 To turn off Zone 2, press the
ZONE 2 [OFF] button.
ZONE 2 OFF
Input selector ZONE 2 indicator
1 Press the [ZONE 2] button, then
point the remote controller at the
AV receiver and press the
[ON/STANDBY] button.
Zone 2 turns on and ZONE 2 indicator
lights up.
2 To select an input source for
Zone 2, press the [ZONE 2]
button, followed by an INPUT
SELECTOR button.
To select AM or FM press the
[TUNER] INPUT SELECTOR button
repeatedly.
Note:
You cannot select different AM or FM
radio stations for your main room,
Zone 2. The same AM/FM radio station
will be heard in each room.
3 To turn off Zone 2, press the
[ZONE 2] button, followed by the
[ON/STANDBY] button.
ZONE2 ON/STANDBY
INPUT
SELECTOR