Omega FoodPro - Manual (Page 13)

14
1. Place the large work bowl onto the
motor housing with the main handle
to the left of the power panel. This
aligns the bowl to properly engage the
safety interlock turn the main handle to
the right until it clicks” or “locks” into
place. The main handle should now be
centered with the Power Panel.
2. The desired size of Slicing or Shredding
should be facing away from the adapter
when installing the disk
3. Place the Slicing or Shredding disk
onto the Disc Adapter. Be sure to align
the center hole of the disk with the
disc adapter.
4. Once the Adapter is inserted into the
Disk, rotate the disk until it is seated.
5. Place the Adapter/Disk Assembly onto
the main motor shaft. You may have to
rotate the assembly partially to properly
“seat” onto the shaft.
6. Place the Work Bowl Cover onto the
Work Bowl with the interlock “tab” to
the left of the main handle. Turn the
Cover to the right until it “clicks” or
“locks” into place. The “tab” should
now be aligned with the Main Handle.
ASSEMBLY–SLICING OR SHREDDING DISK
1.
2.
3.
6.
4.
5.