Omnimount TILT-PA - Manual (Page 4)

4
ID Description Qty
A Philips Screws M4 x 16mm 4
B Philips Screws M4 x 36mm 4
C Philips Screws M4 x 45mm 4
D Philips Screws M5 x 16mm 4
E Philips Screws M5 x 36mm 4
F Philips Screws M5 x 46mm 4
G Philips Screws M6 x 16mm 4
H Philips Screws M6 x 36mm 4
I Philips Screws M6 x 46mm 4
J Philips Screws M8 x 16mm 4
K Philips Screws M8 x 36mm 4
L Philips Screws M8 x 46mm 4
M 5/8" Urethane Spacer 4
N 3/4" Urethane Spacer 4
Description Qty
6mm x 12mm Screws 8
Square Washer 4
Small Hex Wrench 1
Stud Screws 4
5/16" Flange Nuts 4
5/16" Nylock Jam Nuts 4
Large Hex Wrench 1
Parts List
Nylock Jam Nut
Flange Nut
9
NOTE: The outer corners
of the Back Plate must al-
ways be secured. Some
wide Displays will require
the installation of a 6mm
Screw and 6mm Lock Nut
(not included) to secure the
Back Plate.
Step 5 — Secure Sliders and Back Plate (continued)
Step 6 — Hardware Selection
Consult the supplied Hardware Cross Reference list, and locate the appropriate
mounting screws (A-L) for your display
Spacers
Some displays will require the use of a spacer.
There are two spacers provided:
5/8” (16 mm) round nose spacer (M)
3/4” (19 mm) block spacer (N)
The spacers may be used individually, or may be snapped together to create
one large stacked spacer. The spacers have been designed to snap directly into
the mounting rail for ease in handling, and also include two different mounting
holes to manage the various screw sizes.
Generally, the 5/8” Spacer (M) is used on displays with slightly curved backs
and/or recessed mounting lands. The 3/4” Spacer (N) is used on displays with
curved backs, and Stacked Spacers (M&N) will be used on displays with
deeply curved backs and/or protruding accessories.